![]() ![]() Some coworkers suggested using a Linksys WET54G Wireless-G Ethernet Bridge to extend the network. I then tried using Powerline Ethernet devices but I never successfully got those working. It originally on a shelf in the basement but then I moved it up into the rafters in my unfinished basement. If I wanted to use the computer from the backyard, I couldn't unless I piggybacked on my neighbour's signal.Īt first I tried to solve this problem by moving the position of the WAP. I could sit in my kitchen (right above the WAPs location in the basement) and get a reliable signal, but I barely got a Wi-Fi signal in my family room or bedroom. The problem was that the wireless signal was not strong enough to reach throughout my 1700 square foot home. ![]() The cable coax connected to my broadband bridge which was then connected to my 802.11n Apple Time Capsule (TC) WAP. ![]() My Comcast cable broadband connection came in through my garage and basement, so that is where I had placed my wireless access point (WAP). When configuring networks there is never one way to do things as there are so many different configurations and equipment that could be in use and requirements to full fill, so whilst Apple's instructions might be helpful to some users with a particular setup it wouldn't hurt them to give a bit more detail or context in their articles!ĭo you need help setting up or improving your wireless network? Let Qdos help.Being able to get a robust wireless network signal around my house was something that I struggled with for some time. This means that the router simply passes all broadband traffic through to the Airport Express unit and the base-station will manage everything else on the network. So the simple bit - The one step Apple failed to mention in their article is that for a lot of users they will simply need to set their previous router to modem mode only. If you set the range to 192.168.1.* for example the setting will save however the Airport Express unit will be unhappy (flashing amber) because there is another DHCP server on the network (the Virgin Router) and anything plugged into the router will be on a separate IP range to anything connected to the Airport Express units meaning devices will not be able to communicate. An error will come up stating that you can't set the IP range given out by DHCP on the Airport Express as 192.168.0.* because it recognizes that the Virgin Media router is acting as DHCP giving out IP addresses on the same IP range. However the requirement is for a guest network which means that there needs to be a DHCP server that gives out IP addresses on a separate IP range than the main network - so when following the guide by Apple they instruct you to turn on DHCP and NAT on the main Airport Express unit which allows the IP range to be set on both the main wireless and the guest network. This is straight forward when a guest network is not required as a new wireless network can be setup on the base-stations without changing anything on the existing router. (Let's give it the IP address 192.168.0.1) - but now we wanted to add the Airport Express units. Your basic router setup designed to run your whole network. So the techy bit - the previous setup was just a Virgin Media Super Hub that acted as the modem, resolved all DNS and acted as the DHCP server. However this did not work as smoothly as Apple explain on their site and yet the solution is very quick and easy! Now this should be straight forward as the guest network feature is built in and the steps required are explained here by Apple. Recently we setup a wireless network using Apple Airport Express Base-station units with the requirement that there had to be a separate guest network. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |